文章摘要
使用工况对丁腈橡胶硫化胶的磨耗特性的影响研究
Study on Effect of Different Working Conditions on Abrasion Characteristics of NBR Vulcanizates
投稿时间：2024-02-04  修订日期：2024-02-04
DOI：10.12136/j.issn.1000-890X.2025.09.0650
中文关键词: 丁腈橡胶  使用工况  磨耗量  磨耗表面形貌  磨耗表面粗糙度
英文关键词: NBR  working conditions  abrasion loss  abrasion surface morphology  abrasion surface roughness
基金项目:
作者单位E-mail
马川翔 青岛科技大学机电工程学院 1585925128@qq.com 
王泽鹏* 青岛科技大学机电学院 wzp_ww1@126.com 
宋君萍 青岛科技大学  
李鑫炎 青岛科技大学机电工程学院  
摘要点击次数: 51
全文下载次数: 29
中文摘要:
      研究使用工况（转速、转角和负荷）对丁腈橡胶（NBR）硫化胶的磨耗特性的影响。试验分析转速、转角和负荷对NBR硫化胶的磨耗量、磨耗表面形貌及磨耗表面粗糙度的影响。结果表明，随着转速、转角和负荷的增大，NBR硫化胶的磨耗量增大，磨耗表面形貌越来越复杂，磨耗表面粗糙度显著增大。
英文摘要:
      The effect of different working conditions （rotational speed，corner and load） on the abrasion characteristics of nitrile butadiene rubber （NBR） vulcanizates was studied，the effect of rotational speeds，corners and loads on the abrasion losses，abrasion surface morphologies and surface roughnesses of NBR vulcanizates was tested and analyzed.The results showed that as the rotational speed，corner and load increased，the abrasion loss of NBR vulcanizate increased，the abrasion surface morphology became more complex，and the abrasion surface roughness significantly increased.
Author NameAffiliationE-mail
Ma Chuanxiang School of Mechanical and Electrical Engineering,Qingdao University of Science and Technology,Qingdao 1585925128@qq.com 
WANG Zepeng School of Mechanical and Electrical Engineering,Qingdao University of Science and Technology,Qingdao wzp_ww1@126.com 
Song Junping   
Li Xinyan School of Mechanical and Electrical Engineering,Qingdao University of Science and Technology,Qingdao  
查看全文   查看/发表评论  下载PDF阅读器
关闭