文章摘要
新型橡胶破碎机关键部件有限元分析
Finite Element Analysis on Key Parts of New Type of Rubber Crusher
投稿时间：2018-05-10  修订日期：2018-05-10
DOI：10.12136/j.issn.1000-890X.2019.05.0377
中文关键词: 橡胶破碎机  动刀  转子  有限元分析
英文关键词: rubber crusher  moving blade  rotor  finite element analysis
基金项目:山东省自然科学基金 ZR2016EEM45
作者单位E-mail
李　利 青岛科技大学 机电工程学院 917099717@qq.com 
杨林彬 青岛科技大学 机电工程学院  
张德伟* 青岛科技大学 机电工程学院 917099717@qq.com 
万呈呈 青岛科技大学 机电工程学院  
谢　添 青岛科技大学 机电工程学院  
田　倩 青岛科技大学 机电工程学院  
摘要点击次数: 1817
全文下载次数: 664
中文摘要:
      采用ANSYS Workbench软件，基于有限元分析方法对橡胶破碎机的动刀刀刃角进行研究，结果显示刀刃角为42°时，动刀的综合性能最优，且满足强度要求。对转子运行前6阶振型模态分析表明，橡胶破碎机在工作时转轴不会发生共振，满足使用要求。
英文摘要:
      Based on finite element analysis method，the moving blade edge angle of rubber crusher was investigated using ANSYS Workbench software.The results showed that the moving blade with 42° edge angle had best comprehensive performance，and met the strength requirement.The results of the first six mode modal analysis of the rotor showed that the rotating shaft of the crusher would not resonate at work and meet the using requirement.
Author NameAffiliationE-mail
LI Li College of Mechanical and Electrical Engineering,Qingdao University of Science and Technology 917099717@qq.com 
YANG Linbin College of Mechanical and Electrical Engineering,Qingdao University of Science and Technology  
ZHANG Dewei College of Mechanical and Electrical Engineering,Qingdao University of Science and Technology 917099717@qq.com 
WAN Chengcheng College of Mechanical and Electrical Engineering,Qingdao University of Science and Technology  
XIE Tian College of Mechanical and Electrical Engineering,Qingdao University of Science and Technology  
TIAN Qian College of Mechanical and Electrical Engineering,Qingdao University of Science and Technology  
查看全文   查看/发表评论  下载PDF阅读器
关闭