文章摘要
补强填充剂对氯化聚乙烯橡胶发泡材料泡孔结构和性能的影响
Effect of Reinforcing Agents and Fillers on Pore Structure and Property of CM Foam
  
DOI：
中文关键词: 氯化聚乙烯橡胶  发泡材料  泡孔结构  物理性能
英文关键词: CM  foam  pore structure  physical property
基金项目:
作者单位
刘林国 青岛科技大学 橡塑材料与工程教育部重点实验室 
鲁冰雪 青岛科技大学 橡塑材料与工程教育部重点实验室 
张振秀 青岛科技大学 橡塑材料与工程教育部重点实验室 
辛振祥 青岛科技大学 橡塑材料与工程教育部重点实验室 
摘要点击次数: 576
全文下载次数: 273
中文摘要:
      研究白炭黑用量、炭黑粒径和填充剂种类对氯化聚乙烯橡胶(CM）发泡材料物理性能和泡孔结构的影响。结果表明：当白炭黑用量为30份时，CM发泡材料的泡孔尺寸较小且分布均匀；填充炭黑N550的发泡材料具有较大的拉伸强度和较小的压缩永久变形，泡孔小且密；添加轻质碳酸钙的发泡材料泡孔小，泡孔壁薄，填充高岭土的发泡材料泡孔大且均匀。
英文摘要:
      The effects of the addition level of silica，particle size of carbon black and use of other fillers on the physical properties and pore structure of CM foam were investigated.With silica，the pore size of CM foam was smaller and the pores were uniformly distributed when the addition level of silica was 30 phr.Filled with carbon lack N550，the tensile strength of CM foam was higher and the compression set was lower，while the pores had small size and were distributed densely.With light calcium carbonate，the pore size was also small and pore wall was thin.With Kaoline，the pores of CM foam had big size and were well distributed.
Author NameAffiliation
LIU Lin-guo Qingdao University of Science and Technology 
LU Bing-xue Qingdao University of Science and Technology 
ZHANG Zhen-xiu Qingdao University of Science and Technology 
XIN Zhen-xiang Qingdao University of Science and Technology 
查看全文   查看/发表评论  下载PDF阅读器
关闭