| 唐霞,禹国军.低断面轮胎硫化工艺模拟[J].轮胎工业,2016,36(12):742-747 |
二维码（扫一下试试看！） |
| 低断面轮胎硫化工艺模拟 |
| Simulation on Vulcanization Process of Low Section Tire |
| |
| DOI： |
| 中文关键词: 低断面轮胎 工艺优化 硫化程度 温度场 |
| 英文关键词: low section tire process optimization curing degree temperature field |
| 基金项目: |
| 中图分类号:TQ336.1+1；TQ330.6+7 |
|
| 摘要点击次数: 1721 |
| 全文下载次数: 454 |
| 中文摘要: |
| 针对硫化时间、热源温度和预热温度，用ABAQUS有限元软件建立低断面255/30R22轮胎三维模型，并进行了3组对比模拟。结果表明：对温度场影响最大的是热源温度，最小的是预热温度；对硫化程度影响最大的是热源温度，最小的是硫化时间。根据数据分析提出了最优硫化工艺参数。 |
| 英文摘要: |
| In this study，the three-dimensional finite element model of 255/30R22 low section tire was established by ABAQUS and three groups of simulation were compared in order to analyze the influence of curing time，heating source temperature and preheating temperature on the curing process.The results showed that，the greatest influence on the temperature field was from the heat source temperature while the preheating temperature presented the minimum influence.The greatest influence on the curing degree was also from the heat source temperature and the factor with smallest influence was curing time.Based on the data analysis，the optimum process parameters were obtained. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
