| 李晓明,王志平,连永胜,娄召阳,薛欣欣,李小鹏.全钢工程机械子午线轮胎一次法工艺胎体反包帘线弯曲的仿真研究[J].轮胎工业,2025,(3):0183-0187 |
二维码（扫一下试试看！） |
| 全钢工程机械子午线轮胎一次法工艺胎体反包帘线弯曲的仿真研究 |
| Simulation Research on Bending of Carcass Turn-up Cord of All-steel Off-The-Road Radial Tire Using One-step Process |
| 投稿时间：2024-07-19 修订日期：2024-07-19 |
| DOI： |
| 中文关键词: 全钢工程机械子午线轮胎 一次法成型 胎体反包帘线弯曲 成型 硫化 仿真分析 |
| 英文关键词: all-steel off-the-road radial tire one-step method building bending of carcass turn-up cord building vulcanization simulation analysis |
| 基金项目: |
| 中图分类号: |
|
| 摘要点击次数: 128 |
| 全文下载次数: 75 |
| 中文摘要: |
| 以14.00R25全钢工程机械子午线轮胎为例，采用Abaqus软件，针对一次法成型及硫化过程开展仿真研究，重现整个过程中胎体帘线的变化情况。结果表明，通过一次法工艺制造的轮胎，其胎体帘线弯曲现象没有出现在成型阶段，而是出现在硫化定型与合模阶段。该研究可为胎体反包帘线弯曲问题的解决提供参考。 |
| 英文摘要: |
| Taking the 14.00R25 all-steel off-the-road radial tire as an example，Abaqus software was used to conduct simulation research on the one-step method building and vulcanization process，reproducing the changes of the carcass cord throughout the entire process.The results showed that the bending phenomenon of the carcass cord did not occur during the building stage，but rather during the vulcanization setting and mold closing stages for tire manufactured through a one-step method process.This study could provide reference for solving the bending problem of carcass turn-up cord of tire. |
|
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
