| 时金灵,徐云慧,李金珍,王再学,苑爱峰.90/90－18高速无内胎摩托车轮胎的成型工艺设计[J].橡胶科技,2016,14(8):40-42. |
二维码（扫一下试试看！） |
| 90/90－18高速无内胎摩托车轮胎的成型工艺设计 |
| Molding Process Design of 90/90－18 Tubeless Tire for High Speed Motorcycle |
| |
| DOI： |
| 中文关键词: 摩托车轮胎 无内胎 成型工艺 成型机头 施工设计 |
| 英文关键词: motorcycle tire tubeless molding process molding die construction design |
| 基金项目:江苏省高校“青蓝工程”资助项目（QLGC-2013-03） |
| 中图分类号:TQ336.1＋1；U463.341＋.6 |
|
| 摘要点击次数: 1321 |
| 全文下载次数: 649 |
| 中文摘要: |
| 介绍90/90－18高速无内胎摩托车轮胎的成型工艺设计。成型机头：半鼓式，直径 490 mm，宽度 180 mm。施工设计：胎面采用一方一块结构；胎体帘布采用2层930dtex/2V1锦纶帘布，缓冲层采用1层930dtex/2V3锦纶帘布，胎体和缓冲层帘布裁断角度均为（36±0.5）°；气密层主体材料采用溴化丁基橡胶；胎圈采用单钢丝圈结构，钢丝圈排列方式为3×3，钢丝圈包布采用维纶帘布，胎圈包布采用维纶网眼帆布。采用该成型工艺制备的成品轮胎外观合格率高，各项性能达到指标要求。 |
| 英文摘要: |
| The molding process of 90/90－18 tubeless tire for high-speed motorcycle was designed.The diameter and width of half drum forming head were 490 mm and 180 mm，respectively.One formula and one piece structure were used in the tire tread.Two layers of 930dtex/2V1 nylon cord were applied in carcass ply and one layer of 930dtex/2V3 nylon cord was applied in the breaker ply.The cutting angle was set at （36±0.5）° for the cord fabric in both carcass ply and breaker ply.Inner liner was made of bromobutyl rubber.The single steel wire structure was applied in bead with arrangement of 3×3.Vinylon cord fabric and mesh canvas were used in wire chafer and bead chafer，respectively.It was found that the tire appearance pass percentage using this molding process was high and the properties of the finished tire met product requirements. |
|
|
查看全文
查看/发表评论 下载PDF阅读器 |
